THSCC Forums

I was redoing my seat brackets again last week and managed to mangle the threads on one of these. This would be for the 1.8l cars that have the receiver that moves with the seat, and not the type that mounts to the trans tunnel. A standard fastener will cause the belt receiver to rattle all over the place and I can't find a part number for just the bolt. It seems it is only sold with the receiver assembly PN 57-900A and PN 57-920A.

Can you re-thread it? I have a tap and die set you can borrow, but I'm south of Garner. Not sure where you're at

_________________
Rodney

'08 Bullitt mustang, CAM 7
Autox VP '09-'10, President '11-'12, interim President 2nd half of ‘14
proud recipient of the Bowie Grey service award '12
Now just a guy driving a mustang....

Milko does.

Milko has $100 in his pocket from selling the seats. Day late, $100 bucks short.

edit: I have one (probably)

Andrew if you have one that would be awesome. Unfortunately it is beyond re-threading. They got contaminated with some aluminum and then when I was tightening it down into my bracket the entire thing got pretty mashed up. I had it at what felt like around 30ft lbs but being a big bolt I wanted to give it a extra snug and then I felt the whole thing loosen up

I might but Andrew would be faster if he has one just let me know

_________________
1990 Faded Reddish CSP Lite Miata
2002 Electron Blue Corvette Z06
2005 Mazda 6 Wagon
2003 Nissan Pathfinder DTV (Dog Transport Vehicle)