WTB:(UPDATED) NB Miata stuff

jeremy gast · **Posted:** Mon Dec 30, 2013 8:49 am

I have the stock suspension off Wendys 03 Miata. It is the struts and springs no top hats for the front though. Give me a holler.

Dustin Fredrickson · **Posted:** Mon Dec 30, 2013 2:21 pm

I actually think I have 2000 NB tan leather seats left over after I installed race buckets in my old 2000 LS. As I recall (they've been boxed for a few years now) the drivers seat had some normal wear areas, but I don't think any rips. No sliders for the drivers side as these were used on the Momo.

Also, if you want the factory wind deflector (tan), let me know ASAP, it's out for tomorrow's trash.

I should also have some OEM standard springs, and probably the Bilsteins from the "hard-s" suspension package too.

If anything is of serious interest, let me know and I'll make you a good deal. Don't want to dig it out of the attic if not, though ;-)

Alec Moody · **Joined:** Fri Feb 15, 2013 9:02 am **Posts:** 299

I have a set of stock NA drivers side sliders you can have- they might work with the NB seats.

Brett_Murphy · **Joined:** Thu Jan 12, 2012 2:02 pm **Posts:** 355

Don't trash that wind deflector, I'll take it.

As for the rest, I have to get the car here and figure out what I need. It is behind the RX-8 in priority, though.

Dustin Fredrickson · **Posted:** Mon Dec 30, 2013 3:17 pm

Brett_Murphy wrote:

Don't trash that wind deflector, I'll take it.

As for the rest, I have to get the car here and figure out what I need. It is behind the RX-8 in priority, though.

10-4 Wind deflector will be spared

Vincent Keene · **Posted:** Mon Dec 30, 2013 3:19 pm

Dustin Fredrickson wrote:

I actually think I have 2000 NB tan leather seats left over after I installed race buckets in my old 2000 LS. As I recall (they've been boxed for a few years now) the drivers seat had some normal wear areas, but I don't think any rips. No sliders for the drivers side as these were used on the Momo.

I wonder if the NB seats will fit the N/A sliders? Both of my seats need to be replaced, and I'd rather have cloth (because I don't have a granite dash to match), but beggers can't be too choosey.

Brett_Murphy · **Joined:** Thu Jan 12, 2012 2:02 pm **Posts:** 355

Well, I KNOW I need the seats, since there are no seats in the car. I don't know why I wasn't thinking that (Actually I do: NyQuil).

Dustin, what do you think you'll want for those seats? I'll have to find some sliders now.

Dustin Fredrickson · **Posted:** Mon Dec 30, 2013 5:35 pm

Brett_Murphy wrote:

Well, I KNOW I need the seats, since there are no seats in the car. I don't know why I wasn't thinking that (Actually I do: NyQuil).

Dustin, what do you think you'll want for those seats? I'll have to find some sliders now.

PM sent. Note, I bought a part or two from these guys:

Rails for $30: http://www.partsgroup.com/store.aspx?ca ... ior&Page=9

JamesMilko · **Posted:** Mon Dec 30, 2013 6:51 pm

Vincent Keene wrote:

Dustin Fredrickson wrote:

I actually think I have 2000 NB tan leather seats left over after I installed race buckets in my old 2000 LS. As I recall (they've been boxed for a few years now) the drivers seat had some normal wear areas, but I don't think any rips. No sliders for the drivers side as these were used on the Momo.

I wonder if the NB seats will fit the N/A sliders? Both of my seats need to be replaced, and I'd rather have cloth (because I don't have a granite dash to match), but beggers can't be too choosey.

Everything is mix/match for seats.

e:
Early NAs may not have the seat belt receiver on the slider, can't remember for sure.

THSCC Forums

WTB:(UPDATED) NB Miata stuff

Who is online