⚠ Forum Archived — The THSCC forums were discontinued (last post: 2024-05-18). This read-only archive preserves club history. Visit thscc.com →  |  Search this archive with Google: site:forums.thscc.com your search terms

THSCC Forums

Tarheel Sports Car Club Forums
It is currently Tue Apr 07, 2026 10:08 am

View unanswered posts | View active topics


Board index » On Course » Tech Talk

All times are UTC - 5 hours [ DST ]



Post new topic Reply to topic  Page 2 of 2
  [ 16 posts ]  Go to page Previous  1, 2
  Print view Previous topic | Next topic 
Author Message
Chris Schimmel
 Post subject:
PostPosted: Fri Aug 26, 2005 9:10 am 
Offline

Joined: Fri Oct 10, 2003 9:34 am
Posts: 50
Matt,
If the thread is a 1/2 20 thread,you might try ARP .They have a number of different wheel studs in different lengths and spline sizes. I get all my 7/16 20 wheel studs from them.
As I remember ,I chose a drill diameter about half way between the stud diameter and the spline diameter....about .010 to .015 should allow the splines to dig in to the hub and keep everything tight.
Hope this helps.
Chris
PS haven't broken a stud yet!!
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 2 of 2
  [ 16 posts ]  Go to page Previous  1, 2

Board index » On Course » Tech Talk

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group